Arturo EP1000 Trowel Floor is a 3-component, solvent-free, 5 to 12 mm thick floor finish based on epoxy resin with mineral fillers, available in various colours.
Application
Suitable as a durable, seamless finish for cement- and plaster-bound substrates and tile floors.
Arturo EP1000 Trowel Floor is particularly suitable for finishing floors in:
- Industrial halls
- slaughterhouses
- Industrial kitchens
- Workshops
And where high demands are made on mechanical and chemical load-bearing capacity and hygiene. Skirting boards and curbs can also be covered with the Arturo EP1000 Trowel Floor.
Characteristics
- Very high compressive strength
- Impact, impact and wear resistant
- Can be used as a skirting board
- To be applied at a slope
For more product and safety information regarding Arturo EP1000 Trowel floor under the ‘Downloads’ heading above.
Substrate preparation
Remove cement skins and concrete residues by grinding and sanding. Roughen smooth and dense surfaces (such as those of concrete) by means of dust-free shot blasting. Roughen anhydrite floors and remove any skin by blasting or sanding (depending on the skin tensile strength). Treat contaminated surfaces by means of chemical cleaning.
Sand afterwards. Then always make the floor dust-free by vacuuming with an industrial vacuum cleaner. Fill cuts and holes with a suitable filler. Holes and tears fix me Arturo EP1500 Repair Mortar *.
Pre-treat cement- and plaster-bound substrates with Arturo EP6500 Primer * and/or Arturo EP6200 Scratch Coat *.
Consumption
Approximately 2.00 kg per m2 per mm of layer thickness. At a desired layer thickness of, for example, 5 mm, the consumption will be 10.00 kg per m2.
More information?
For more extensive product, application and safety information regarding Arturo EP1000 Trowel Floor, please see the ‘Product Attachments’ heading above.
Reviews
There are no reviews yet.